On-board processing concepts for future satellite communications systems

The initial definition of on-board processing for an advanced satellite communications system to service domestic markets in the 1990's is discussed. An exemplar system with both RF on-board switching and demodulation/remodulation baseband processing is used to identify important issues related to system implementation, cost, and technology development. Analyses of spectrum-efficient modulation, coding, and system control techniques are summarized. Implementations for an RF switch and baseband processor are described. Among the major conclusions listed is the need for high gain satellites capable of handling tens of simultaneous beams for the efficient reuse of the 2.5 GHz 30/20 frequency band. Several scanning beams are recommended in addition to the fixed beams. Low power solid state 20 GHz GaAs FET power amplifiers in the 5W range and a general purpose digital baseband processor with gigahertz logic speeds and megabits of memory are also recommended

Bond Strength of Direct and Indirect Bonded Brackets After Thermocycling

Thermocycling simulates the temperature dynamics in the oral environment. With direct bonding, thermocycling reduces the bond strength of orthodontic adhesives to tooth structure. The purpose of this study was to evaluate the shear bond strengths (SBS) of one direct and two indirect bonding methods/adhesives after thermocycling. Sixty human premolars were divided into three groups. Teeth in group 1 were bonded directly with Transbond XT. Teeth in group 2 were indirect bonded with Transbond XT/Sondhi Rapid Set, which is chemically cured. Teeth in group 3 were indirect bonded with Enlight LV/Orthosolo and light cured. Each sample was thermocycled between 5°C and 55°C for 500 cycles. Mean SBS in groups 1, 2, and 3 were not statistically significantly different (13.6 ± 2.9, 12.3 ± 3.0, and 11.6 ± 3.2 MPa, respectively; P \u3e .05). However, when these values were compared with the results of a previous study using the same protocol, but without thermocycling, the SBS was reduced significantly (P = .001). Weibull analysis further showed that group 3 had the lowest bonding survival rate at the minimum clinically acceptable bond-strength range. The Adhesive Remnant Index was also determined, and group 2 had a significantly (P \u3c .05) higher percentage of bond failures at the resin/enamel interface

A Comparison of Bond Strength Between Direct- and Indirect-bonding Methods

The purpose of this study was to evaluate and compare the shear bond strength and the sites of bond failure for brackets bonded to teeth, using two indirect-bonding material protocols and a direct-bonding technique. Sixty extracted human premolars were collected and randomly divided into three groups. The direct-bonded group (group 1) used a light-cured adhesive and primer (Transbond XT). One indirect-bonded group (group 2) consisted of a chemical-cured primer (Sondhi Rapid Set) and light-cured adhesive (Transbond XT), whereas the other group (group 3) used a light-cured primer (Orthosolo) and adhesive (Enlight LV). Forty hours after bonding, the samples were debonded. Mean shear bond strengths were 16.27, 13.83, and 14.76 MPa for groups 1, 2, and 3, respectively. A one-way analysis of variance showed no significant difference in mean bond strength between groups (P = .21). Furthermore, a Weibull analysis showed all three groups tested provided over a 90% survival rate at normal masticatory and orthodontic force levels. For each tooth, an Adhesive Remnant Index (ARI) score was determined. Group 2 was found to have a significantly lower ARI score (P \u3c .05) compared with groups 1 and 3. In addition, Pearson correlation coefficients indicated no strong correlation between bond strength and ARI score within or across all groups

Second year technical report on-board processing for future satellite communications systems

Advanced baseband and microwave switching techniques for large domestic communications satellites operating in the 30/20 GHz frequency bands are discussed. The nominal baseband processor throughput is one million packets per second (1.6 Gb/s) from one thousand T1 carrier rate customer premises terminals. A frequency reuse factor of sixteen is assumed by using 16 spot antenna beams with the same 100 MHz bandwidth per beam and a modulation with a one b/s per Hz bandwidth efficiency. Eight of the beams are fixed on major metropolitan areas and eight are scanning beams which periodically cover the remainder of the U.S. under dynamic control. User signals are regenerated (demodulated/remodulated) and message packages are reformatted on board. Frequency division multiple access and time division multiplex are employed on the uplinks and downlinks, respectively, for terminals within the coverage area and dwell interval of a scanning beam. Link establishment and packet routing protocols are defined. Also described is a detailed design of a separate 100 x 100 microwave switch capable of handling nonregenerated signals occupying the remaining 2.4 GHz bandwidth with 60 dB of isolation, at an estimated weight and power consumption of approximately 400 kg and 100 W, respectively

Quantum Criticality in Dimerized Spin Ladders

We analyze a possibility of quantum criticality (gaplessness) in dimerized antiferromagnetic two- and three-leg spin-1/2 ladders. Contrary to earlier studies of these models, we examine different dimerization patterns in the ladder. We find that ladders with the columnar dimerization order have lower zero-temperature energies and they are always gapped. For the staggered dimerization order, we find the quantum critical lines, in agreement with earlier analyses. The bond mean-field theory we apply, demonstrates its quantitative accuracy and agrees with available numerical results. We conclude that unless some mechanism for locking dimerization into the energetically less favorable staggered configuration is provided, the dimerized ladders do not order into the phase where the quantum criticality occurs.Comment: 7 pages, 9 figure

Lupus-TR-3b: A Low-Mass Transiting Hot Jupiter in the Galactic Plane?

We present a strong case for a transiting Hot Jupiter planet identified during a single-field transit survey towards the Lupus Galactic plane. The object, Lupus-TR-3b, transits a V=17.4 K1V host star every 3.91405d. Spectroscopy and stellar colors indicate a host star with effective temperature 5000 +/- 150K, with a stellar mass and radius of 0.87 +/- 0.04M_sun and 0.82 +/- 0.05R_sun, respectively. Limb-darkened transit fitting yields a companion radius of 0.89 +/- 0.07R_J and an orbital inclination of 88.3 +1.3/-0.8 deg. Magellan 6.5m MIKE radial velocity measurements reveal a 2.4 sigma K=114 +/- 25m/s sinusoidal variation in phase with the transit ephemeris. The resulting mass is 0.81 +/- 0.18M_J and density 1.4 +/- 0.4g/cm^3. Y-band PANIC image deconvolution reveal a V>=21 red neighbor 0.4'' away which, although highly unlikely, we cannot conclusively rule out as a blended binary with current data. However, blend simulations show that only the most unusual binary system can reproduce our observations. This object is very likely a planet, detected from a highly efficient observational strategy. Lupus-TR-3b constitutes the faintest ground-based detection to date, and one of the lowest mass Hot Jupiters known.Comment: 4 pages, 4 figures, accepted for publication in ApJ

Co-Infection by Chytrid Fungus and Ranaviruses in Wild and Harvested Frogs in the Tropical Andes.

While global amphibian declines are associated with the spread of Batrachochytrium dendrobatidis (Bd), undetected concurrent co-infection by other pathogens may be little recognized threats to amphibians. Emerging viruses in the genus Ranavirus (Rv) also cause die-offs of amphibians and other ectotherms, but the extent of their distribution globally, or how co-infections with Bd impact amphibians are poorly understood. We provide the first report of Bd and Rv co-infection in South America, and the first report of Rv infections in the amphibian biodiversity hotspot of the Peruvian Andes, where Bd is associated with extinctions. Using these data, we tested the hypothesis that Bd or Rv parasites facilitate co-infection, as assessed by parasite abundance or infection intensity within individual adult frogs. Co-infection occurred in 30% of stream-dwelling frogs; 65% were infected by Bd and 40% by Rv. Among terrestrial, direct-developing Pristimantis frogs 40% were infected by Bd, 35% by Rv, and 20% co-infected. In Telmatobius frogs harvested for the live-trade 49% were co-infected, 92% were infected by Bd, and 53% by Rv. Median Bd and Rv loads were similar in both wild (Bd = 101.2 Ze, Rv = 102.3 viral copies) and harvested frogs (Bd = 103.1 Ze, Rv = 102.7 viral copies). While neither parasite abundance nor infection intensity were associated with co-infection patterns in adults, these data did not include the most susceptible larval and metamorphic life stages. These findings suggest Rv distribution is global and that co-infection among these parasites may be common. These results raise conservation concerns, but greater testing is necessary to determine if parasite interactions increase amphibian vulnerability to secondary infections across differing life stages, and constitute a previously undetected threat to declining populations. Greater surveillance of parasite interactions may increase our capacity to contain and mitigate the impacts of these and other wildlife diseases

Functional and genetic screening of acute myeloid leukemia associated with mediastinal germ cell tumor identifies MEK inhibitor as an active clinical agent

Table of genes tested by the next-generation sequencing panel. (PPTX 58.1 kb